TRAC Outdoors

TRAC Outdoors marine pumps are used to manage water on boats, including removing bilge water, pumping waste, delivering pressurized washdown water, and handling thru-hull drainage. Different pump types in the TRAC Outdoors lineup are built for specific onboard tasks, so choosing the right one depends on where and how water needs to be moved.

Electric anchor winches are designed for boaters who anchor frequently or in deep water and want a faster, less physically demanding way to deploy and retrieve their anchor. They are especially useful for solo anglers, older boaters, or anyone operating a heavier vessel where pulling an anchor by hand is impractical or exhausting.

Start by matching the pump's GPH rating to your boat's size and the volume of water it may need to clear in an emergency. Smaller boats typically do well with a 600 GPH pump, while larger vessels benefit from 800 GPH or higher. Also consider whether you want an automatic pump that activates on its own or a manual non-automatic model.

An automatic bilge pump activates on its own when its built-in float switch detects rising water, while a non-automatic bilge pump only runs when manually switched on. Automatic models offer peace of mind when you are away from the boat, but non-automatic versions are simpler and often preferred by boaters who want direct control over when the pump runs.

Yes, a wireless remote can be used to control compatible electric anchor winches, allowing you to deploy or retrieve your anchor from anywhere on the deck without being tethered to a fixed switch. Compatibility matters, so make sure the wireless remote you choose is rated for the specific generation of anchor winch installed on your boat.

Rinse the bilge pump and its housing with fresh water after each use in saltwater to prevent corrosion and debris buildup. Periodically inspect the float switch on automatic models to make sure it moves freely and activates correctly. Check all electrical connections for signs of corrosion and clear any debris from the pump intake to keep it running efficiently.

No, a macerator pump is not the same as a bilge pump. A macerator pump is specifically designed to grind and discharge waste from onboard holding tanks, while a bilge pump removes unwanted water from the lowest part of the hull. Using the wrong pump type for either task can damage the pump and create compliance issues.

When buying a washdown pump for a boat, look for a model rated for marine use that delivers enough pressure to clean fish, rinse gear, or wash down the deck effectively. Confirm the pump is compatible with your boat's 12V electrical system and check whether it includes the fittings and hose connections needed for installation.

Yes, the size and load rating of an electric anchor winch absolutely matters depending on your boat type and anchor weight. Pontoon boats, deck boats, and fishing boats all have different weight profiles and anchoring needs, so using an undersized winch can strain the motor and lead to premature failure. Always match the winch's rated capacity to your anchor and rode weight.

Because a submersible thru-hull pump is designed to discharge water directly through the hull at a fixed location, making it a better fit for applications that require continuous or high-volume drainage rather than occasional bilge clearing. Standard bilge pumps sit inside the hull and handle incidental water accumulation, while thru-hull models are suited for more demanding or permanent installations.