Your Cart is Empty
Electrical - Accessories
Sort by:
Connect, Monitor, and Expand Your Victron System — Electrical Accessories That Keep Every Component Talking
Electrical accessories are the connective tissue of any well-built off-grid or marine power setup, and this collection brings together over 500 options purpose-built for Victron Energy systems. Whether you're integrating a solar charge controller with a battery monitor, bridging your inverter to a laptop for firmware updates, or extending a data cable across a large vessel or vehicle, you'll find the right interface, adapter, or cable here. Every product is designed to maintain reliable communication between Victron components so your system performs exactly as intended.
What This Collection Covers — and Why It Matters for Your Build
- Seamless system monitoring on the go — the Victron VE.Direct to USB Interface lets you connect charge controllers and battery monitors directly to a laptop or PC for real-time data logging and configuration.
- Full inverter/charger configuration from a computer — the Victron MK3-USB Interface Module bridges the VE.Bus to USB, making it straightforward to program Multi and Quattro inverter/chargers without proprietary hardware.
- Reach devices in tight or distant installations — right-angle VE.Direct cables in lengths from 0.3 m to 10 m accommodate cramped battery compartments and long runs alike; the 10 m VE.Direct cable is especially useful for roof-mounted solar controllers wired to a below-deck monitor.
- Integrate Victron data into a marine chartplotter network — the VE.Can to NMEA 2000 Micro-C Male Cable allows battery and solar data to appear directly on NMEA 2000-compatible displays.
- Flexible RJ45 UTP cable lengths for GX device networking — available from 0.3 m to 30 m, these cables connect GX devices to VE.Bus equipment cleanly and without signal loss over distance.
Choosing the Right Victron Accessory for Your Installation
The most important first step is identifying which Victron communication protocol your devices use. VE.Direct is common on smaller, standalone units like the SmartSolar MPPT and BMV battery monitors. VE.Bus is used by Multi and Quattro inverter/chargers and requires the MK3-USB interface for computer connectivity. VE.Can handles high-speed communication between GX devices and compatible components, including NMEA 2000 networks on boats.
Cable length is the next practical consideration. For installations where a controller sits right beside a monitor, a 3 m VE.Direct cable is usually sufficient. Larger builds — think a converted sprinter van with solar on the roof or a sailing catamaran with distributed components — benefit from the longer options. When in doubt, measure the actual cable run before ordering; a little extra length is far easier to manage than coming up short.